Toto NEOREST MS990CG - Manual (Page 11)

11
Before Using the NEOREST 600
Introduction
close
open
battery cover
2 AA batteries
back side
Remote Control Display
Preparation
Insert batteries into the remote controller.
➀
Remove the remote controller from its wall hanger.
● Grasp the remote controller at each side and pull straight
up.
➁
Open the battery cover on the back of the remote
controller.
➂
Insert 2 AA batteries into the battery compartment.
➃
Close the battery cover. 1
● If the batteries are properly inserted, the remote controller
display will appear as in the figure shown at the right.
● Use alkaline dry cell batteries.
● Adhere to the following precautions to prevent battery acid leakage.
● Use the same type of batteries each time you replace batteries.
● Remove the batteries from the battery compartment when not using the remote controller for extended periods of time.
● Do not use rechargeable batteries.
Settings (temperature, energy saving and time) may be lost when replacing batteries. Be sure to reset the desired settings after
installing new batteries.
Regarding dry cell batteries
1 Turn the Main Unit controls to OFF when replacing the batteries or cleaning the unit to avoid
pushing other buttons and enabling unnecessary functions, such as flushing or opening and closing
the lid.