Toto NEOREST MS990CG - Manual (Page 37)

37
Maintenance
Cleaning the toilet bowl.
●
The toilet bowl can easily be cleaned while flushing with water. Perform routine cleaning of the toilet bowl.
✲ Be careful not to get toilet bowl cleaner on the plastic components.
Clean the toilet bowl with toilet bowl cleaner before pushing the
"Rinse Cycle" button.
● After using toilet bowl cleaner or disinfectant to clean the toilet bowl, flush the bowl
right away (within 3 minutes) and leave the toilet seat and seat cover open. Wipe away any cleaner that spills
onto the toilet seat. (To prevent evaporated gas from the toilet bowl cleaner from getting into the main unit of
the Washlet.)
If you want to stop the Rinse Cycle:
● Push the "Rinse Cycle" button, the unit will flush once and then refill.
During the Rinse Cycle, pushing the button again
will move to the next step of the cycle before 30
seconds is up.
2
3
Flush the toilet bowl.
Rinse Cycle
ON/OFF button
Clean the toilet bowl.
● Clean the toilet bowl while the water is being
sprayed into the bowl.
● Water swirls to wash the bowl for 30 seconds.
Toilet automatically switches to Flush mode
● Flush mode lasts for 30 seconds.
● Clean bottom of bowl (trap-way).
Water swirls into the toilet bowl
The water in the toilet
bowl gets flushed.
2 Cleaning the toilet bowl
● Cleaning solution can be used to wash the toilet bowl, but be sure to
flush out the toilet bowl immediately after use to prevent it from staining
the toilet bowl.
3 Pushing the "Rinse Cycle" button again at any time will interrupt the cycle,
stop the water flow and refills the water automatically.
● Push Rinse Cycle button
Automatically refills bowl