Toto NEOREST MS990CG - Manual (Page 23)

23
Operation
Using the Energy Saver Feature - “TIMER ON/OFF”
You can set your Neorest to turn off the seat heater to save energy by pressing the “TIMER ON/OFF”
button. The heater turns off for 3, 6 or 9 hours to save energy. Each day afterwards, the NEOREST
automatically goes into Energy Saver mode at the same time.
Open the remote control cover and press the “Timer” button at the time you want the
Energy Saver feature to begin operating.
● “Timer” and “Saving Time 3 hrs.” appear in the remote control display, and a beep sounds.
● The “Energy Saver - Timer” lamp in the main unit display lights.
● The seat heater turns off and energy saving starts.
2KID
Press the “TIMER ON/OFF” button repeatedly to set the duration.
● Every time you press “TIMER ON/OFF”, the display changes.
● Select the duration you want to set.
2KID
● The saving time is initially set for 3 hours.
● When batteries for the remote control are replaced, the settings will be cleared. Reset the settings.
● When you expect freezing temperatures, keep the room warm so that the room temperature does not fall below
freezing, and turn off the Energy Saver feature.
● In case the power cord is disconnected or a power failure occurs, the timer may not operate as originally set
starting on the following day.
Notes
● You can always change the energy saving duration without changing the energy saving start time.
● If you wish to change the energy saving start time, turn off the energy saving timer and press the “Timer
ON/OFF” button again at the new time.
Notes
To Conserve Energy