Toto NEOREST MS990CG - Manual (Page 44)

44
Toilet Seat Sensor
ProblemPossible Cause Solution
Make sure that the sensors are not
covered, as this will prevent the
infrared light from projecting.
(See page 14.)
Remove any dirt or water that is on the
toilet seat sensor.
Change your position on the toilet seat
or raise the clothing you are wearing
to allow the sensor to detect bare skin.
Make sure that the sensors are not
covered, as this will prevent the
infrared light from projecting.
Even when not seated
on the toilet seat, the
"Rear Wash", "Air
deodorizer" and
"Warm Air Dryer"
functions turn on
when the buttons are
pushed. Is the toilet seat sensor covered with something?
Is the toilet seat sensor dirty or wet?
The sensors in the toilet seat sensor may not
work properly depending upon the way in which
the user sits on the toilet seat, or stands in front
of it, or the color of the clothing or type of fabric
worn.
Is the toilet seat sensor covered up by your
clothing? Are the sensors covered with dust or
water?
Even when seated on
the toilet seat, the
"Rear Wash", "Air
deodorizer" and
"Warm Air Dryer"
functions do not turn
on when the buttons
are pushed.
Auto Flush
ProblemPossible Cause Solution
Push the Auto Flush on the remote
controller to turn it ON.
(See page 21~22.)
Use the "Flush" button on the remote
controller to flush the toilet.
Make sure that the sensors are not
covered, as this will prevent the
infrared light from projecting.
—
Remove any dirt or water that is on the
toilet seat sensor or motion detection
sensor.
Do not hang any decorations or
fixtures directly in front of the unit.
Sit for more than 6 seconds. See page
21.
Stand in front for more than 6
seconds. See page 22.
The toilet bowl flush
function does not
automatically turn on.
Is the Auto Flush function OFF? When it is OFF,
the "Flush" light on the remote controller display
will not be lit up.
Once the Auto Flush button has been pushed,
the Auto Flush function will not operate again
until 60 seconds have passed.
Is the toilet seat sensor or motion detection
sensor covered with something?
When the remote controller is used to flush the
toilet, the Auto Flush function will not
operate.However, if the motion detection sensor
continues to detect motion for more than 60
seconds, the Auto Flush function will operate.
Is the toilet seat sensor or motion detection
sensor dirty or wet?
Are there any wall hangings or fixtures located
directly in front of the toilet?
In case of sitting for less than 6 seconds, the
automatic flush will not activate.
When both seat and lid are opened, but it is not
stood in front of for more than 6 seconds, the
automatic flush will not activate.