Tunturi R25 User Manual

Page 6

Advertising
background image

6

OWNER

'S

M

ANU

AL

R

25

rate, press RECOVERY. The display also shows

the word ”Recovery”.

2.

The measuring starts automatically and takes

two minutes.

3.

Upon completion of the measurement,

the display shows the recovery rate as a

percentage. The smaller the rate, the fitter

you are. Please note that your results are in a

relation to the pulse level in the beginning of

the measurement, and that your results are

personal and cannot directly be compared with

any other person’s results. In order to improve

the reliability of recovery pulse measurement,

always try to standardize the measurement

situation as accurately as possible; start

measuring at the same heart rate level as

precisely as possible.

4.

To switch back to the main display by

pressing RESET. The console will also

automatically switch to the main display

one minute after the completion of the

measurement.

TRANSPORT AND STORAGE

Move the device according to the following

instruction, because lifting the rower

incorrectly may strain your back or cause other

risk of accidents:

Stand behind the device and grip the rail with

one hand and the seat with the other. Tilt the

device so that is rests on the transportation

wheels. Move the device by wheeling it on

transportation wheels. Lower the device onto

floor while holding on to the rail and the seat,all

the time remaining behind the device.

Transport the equipment with caution over

uneven surfaces, for example over a step.

The equipment should never be transported

upstairs using the wheels over the steps,

instead it must be carried. We recommend that

you use a protective base when transporting

the equipment.

To prevent malfunctioning of the rower, store in

a dry place with as little temperature variation

as possible, protected from dust.

MAINTENANCE

The R25 requires very little maintenance.

Check, however, from time to time that all

screws and nuts are tight.

Clean the rower with a damp cloth. Do not

use solvents.

Never remove the protective covers.

Clean the inner surfaces of the rail if necessary

so that the seat moves as smoothly and quietly

as possible.

CHANGING BATTERIES

The console gives a warning signal before the

change of batteries is due. Remove the battery

compartment cover from the back side of the

meter and remove old batteries. Place new

batteries in the holder (note the direction of the

batteries) and reattach the cover. To minimize

the strain on the resistance mechanism, we

recommend that the resistance adjustment

knob is set to position 1 after every training

session.

MALFUNCTIONS

Despite continuous quality control, defects and

malfunctions caused by individual components

may occur in the equipment. In most cases

it’s unnecessary to take the whole device in

for repair, as it’s usually sufficient to replace

the defective part. If the equipment does not

function properly during use, contact your

Tunturi dealer immediately. Always give the

model and serial number of your equipment.

Please state also the nature of the problem,

conditions of use and purchase date.

If you require spare parts, always give the

model, serial number of your equipment and

the spare part number for the part you need.

The spare part list is at the back of this manual.

Use only spare parts mentioned in the spare

part list.

TECHNICAL SPECIFICATIONS

Length (folded) ......................201 (94) cm

Width (folded) ........................... 53 (53) cm

Height (folded) .......................65 (124) cm

Weight ...............................................31,6 kg

The R25 meets EN precision and safety

standards (EN-957).

Due to our continuous policy of product

development, Tunturi reserves the right to

change specifications without notice.

NOTE!

The instructions must be followed

carefully in the assembly, use and maintenance

of your equipment. The warranty does not

cover damage due to negligence of the

assembly, adjustment and maintenance

instructions described herein. Changes or

modifications not expressly approved by

Tunturi will void the user's authority to operate

the equipment!

We wish you many enjoyable trainings with

your new Tunturi training partner!

Advertising