Tyco Electronics P5200 - Manual (Page 111)

MM23772, Rev. F
111
If system selection is programmed to the SYSTEM/CHANNEL Selection knob, direct
access to systems will not be available. Pressing  or  will scroll through different
sets of 16 systems each (banks) if more than 16 systems are programmed into the
radio. The systems within each bank are then selectable via the SYSTEM/CHANNEL
Selection knob as described previously in METHOD 1.
Example of Method 3:
System: 1 = North Group: 1 = Group 1
2 = South 2 = Group 2
3 = East 3 = Group 3
4 = West 4 = Group 4
1. Press

to the System Select Mode.
2. Press to select “West” system.
3. Press  . West is the newly selected system.
11.8 CHANNEL SELECTION
Several methods can be used to select a new channel.
METHOD 1: If channel selection is programmed to the SYSTEM/CHANNEL Selection knob, select
a channel by turning the SYSTEM/CHANNEL Selection knob to the desired group
number position. The display registers the new channel name on line two. If the knob is
moved to a position greater than the number of programmed channels, the highest
programmed channel will remain selected. The  button can be programmed to
provide access to a “2
nd
bank” of 16 channel number positions (17-32).
METHOD 2: (P7270, P7250, and P5250 model radios) From keypad: If channel selection is
programmed as the primary function of  and , select a channel by pressing  or
 to scroll through the channel list. The display registers the new channel name on
line two.
11.9 MODIFY SCAN LIST
11.9.1 P7270 Model
1. Press
to toggle scan OFF and verify is not displayed.
2. Select group or channel.
3. Press  once to remove group or channel from list.
4. Press once to add as a normal channel.
5. Press twice to add as a Priority 2 channel.
6. Press three times to add as a Priority 1 channel.
7. Press to re-start scanning.