Tyco Electronics P5200 - Manual (Page 85)

MM23772, Rev. F
85
9.29.5 Scan Lockout Mode
Following the transmission or reception of a data call, if scan is enabled, scanning will stop temporarily
(two independent pre-programmed times; after a receive data call and after a transmit data call). During
this time the scan indicator will flash to indicate that scan is enabled but temporarily suspended. This
mode is normally exited when the pre-programmed time expires; however, the following actions will
terminate the scan lockout mode before the timeout is completed:
•
The CLEAR button is pressed.
•
The PTT button is pressed.
•
The group or system is changed.
•
Phone call mode is entered.
•
Individual call mode is entered.
•
A new emergency assignment has been received.
•
An emergency is declared or cleared.
•
An individual or phone call is received.
•
An Agency, Fleet or System All Call is received.
•  or is pressed to toggle Scan ON or OFF.
9.29.6 Data Lockout Mode
During the voice call scan hang time (pre-programmed) the radio will not receive data calls.
9.30 PAGE (P25 TRUNKED ONLY)
Page sends a PING message to a radio and functions similar to Individual Call.
The following procedures describe how to initiate and complete a Pre-Stored Page.
1. To select a pre-stored individual phone number, enter the Page mode using the  and the  or 
key until PAGE is displayed. Select Page with the  key. Then scroll through the list of stored
numbers using the  or  key.
2. Press the PTT button. If the receiving radio receives the Page and responds, both radios will emit
three high-pitched tones.