Tyco Electronics P5200 - Manual (Page 17)

MM23772, Rev. F
17
4.4 CHANGE THE BATTERY PACK
4.4.1 Remove the Battery Pack
Make sure the power to the radio is turned OFF.
CAUTION
Although the P7200 and P5200 have been designed to tolerate changing the battery pack
without turning power off, M/A-COM, Inc. recommends turning radios off before
changing battery packs to ensure safety and best operation.
1. Press the latch at the bottom of the battery pack.
2. Lift the battery pack from the bottom.
3. Remove the battery pack from the radio.
Figure 4-1: Removing the Battery Pack
4.4.2 Attach the Battery Pack
Make sure the power to the radio is turned OFF.
1. Align the tab on the top of the battery pack with the slot at the top of the battery cavity.
2. Push the battery pack down to attach the battery to the radio.
3. Verify that the battery pack is properly latched to the radio.
Figure 4-2: Attaching the Battery Pack