Tyco Electronics P5200 - Manual (Page 45)

MM23772, Rev. F
45
8.24.1 Manually Dialing a Selective Call (P7270 Only)
1. Enter *8, the User ID number of the user being called, and the # key (no dashes or spaces). This
feature must be enabled by the administrator.
*8<destination user id>#
A shortened User ID number can be dialed using the following guidelines:
• If the radio being called is in the same region and agency – enter only the last four digits.
• If the radio being called is in the same region, but a different agency – enter the last seven digits.
• If the radio being called is in another region or if the area is unknown – enter all ten digits.
2. Press PTT (and release) to ring the other user.
The ring tone is sounded.
If the other user accepts the call, the called user’s alias will appear in initiating caller’s display. The
two are now in a private call until one ends the call, the call is terminated due to an initiated
emergency, or the maximum time limit of ten (10) minutes is reached.
Table 8-8 lists and defines the messages that are displayed by the radio during a selective call.
Table 8-8: Status of Selective Call
STATUS MESSAGE DEFINITION
Busy Peer is involved in another selective/PSTN call.
Disconnect
Selective/PSTN call was terminated for unknown
reason.
Network Err
Selective/PSTN call cannot continue because of
an unspecified network error.
Reject
Peer or this user declined request to establish
selective/PSTN call.
Unavailable Peer cannot be reached for selective/PSTN call.
Calling Calling peer (i.e., for selective or PSTN calls).
Connecting Establishing selective/PSTN call with peer.
Hangup Peer or this user terminated selective/PSTN call.
Lim 10 min Selective/PSTN call limited to 10 minutes.
Timing Out
Selective/PSTN call has 10 seconds remaining
before limit is reached (shown for 5 seconds).
Sel Call Selective call is active.
8.24.2 Selective Call Using Speed Dial
Speed dial numbers are defined and provisioned by the OpenSky network administrator
and cannot be manually entered into the radio by the user. Contact the administrator if
changes to the speed dial list are required.
1. Scroll through the Menu options using the  or  button until “Speed Dial” appears in the second
line of the display. Using the  or  keys, scroll through the pre-programmed speed-dial numbers
until the desired number appears in the display and press the PTT button.
OR