Tektronix 200 Series - Manual (Page 66)

5 TCP/IP Configuration
5-2 Network Utilities for Phaser Color Printers
Before you begin
■ Do not turn on the printer yet. Your printer should be set up and
connected to the network. See your printerÕs user manual for
information about setting up the printer. For information about
connecting the printer to the network, see ÒEthernet connectionÓ
on page 2-6.
■ Install the Þles from the UNIX version of your printerÕs network
utilities diskettes on the hard disk of the workstation you will be
using for the TCP/IP conÞguration. For more information, see
ÒInstalling Þles from your printerÕs network utilities diskettesÓ on
page 5-3 or ÒDownloading Þles from the Tektronix Color Printer
Information ServerÓ on page 5-4.
■ Obtain the information listed in the following table. It might be
helpful to write this information down so you can refer to it later
when you are performing the conÞguration.
Required information for TCP/IP conÞguration
Information Comments
Internet (IP) address for the printer Format is x.x.x.x, where x represents a decimal number from 0 - 255.
Network mask If you are unsure, leave this blank; the printer will choose an appropriate
mask.
Broadcast address This is the address the printer uses to send broadcast packets. Regardless
of how this parameter is set, the printer accepts broadcast packets from any
of the commonly used broadcast address conventions.*
If you are unsure, leave this blank; the printer will select an appropriate
broadcast address.
Gateway IP address You need this address if you want to communicate with the printer from
anywhere other than the local network segment.
* The printer accepts packets with any ÒoldÓ (Òall zerosÓ) or ÒnewÓ (Òall onesÓ) style broadcast addresses. It also
accepts the IP Òall hostsÓ multicast address and user-speciÞed broadcast addresses.