Tektronix 200 Series - Manual (Page 7)

User Manual 1-1
Chapter
1
Introduction
How to use this manual
This manual provides information needed by system administrators and
others who need to install Tektronix color printers equipped with an internal
Ethernet interface. Tektronix printers that do not support the internal
Ethernet interface can be attached to Ethernet networks by using the
Tektronix 4511A Network Interface. The 4511A Network Interface supports
the TCP/IP protocol (Transmission Control Protocol/Internet Protocol). See
your authorized Tektronix representative for 4511A ordering information.
■ Before using this manual, you should unpack and set up your
Tektronix printer. You should also install the appropriate drivers
on any PC and Macintosh computers on your network.
Instructions for these unpacking, set-up, and installation tasks are
contained in your printerÕs user manual and the manual that is
shipped with your Tektronix printerÕs drivers and utilities
diskettes.
■ After your printer is set up, use this network manual in
conjunction with your printerÕs network utilities diskettes to
conÞgure the printer for network operation.
Chapter 2 of this manual contains general information about the internal
network interface in Tektronix color printers. Whether you are installing the
printer into an EtherTalk, NetWare, TCP/IP, or mixed environment, you
should read this chapter.
Chapters 3, 4, and 5 explain conÞguration for EtherTalk, NetWare, and
TCP/IP respectively. Read the chapter(s) appropriate for your network.