Transition Networks SISTM10XX-162-LR - Manual (Page 34)

29
Power Alarm Configuration
Power alarm function enables the Relay alarm action. Without enabling power alarm function, the
Relay alarm action will not work even the Relay alarm is set.
•
Mark the check box and click Apply button
Power Alarm interface
IP Configuration
User can configure the IP Settings and DHCP client function
• DHCP Client: To enable or disable the DHCP client function. When DHCP client function is
enabling, the industrial switch will be assigned the IP address from the network DHCP server.
The default IP address will be replace by the DHCP server assigned IP address. After user click
“Apply” button, a popup dialog show up. It is to inform the user that when the DHCP client is
enabling, the current IP will lose and user should find the new IP on the DHCP server. To cancel
the enabling DHCP client function, click “cancel”
• IP Address: Assign the IP address that the network is using. If DHCP client function is enabling,
and then user don’t need to assign the IP address. And, the network DHCP server will assign
the IP address for the industrial switch and display in this column. The default IP is 192.168.16.1
• Subnet Mask: Assign the subnet mask of the IP address. If DHCP client function is enabling,
and then user do not need to assign the subnet mask
• Gateway: Assign the network gateway for the industrial switch. The default gateway is
192.168.16.254
• And then, click Apply button