Uniden WDECT 2345+1 - Manual (Page 18)

! Your phone may
be compatible
with other
Uniden Digital
Expandable
Systems.
Please visit our
website at
for model
number
confirmation.
www.uniden.com.au,
www.uniden.co.nz
Register the Handset
If you purchase an expansion handset (WDECT2305 model), you need to register
the handset before use. Only one handset can be registered at a time.
Handsets supplied with the phone are registered to the base by the factory. When
charged, pre-registered handsets display a handset ID number. Handsets that
have not been registered display When
you register an extra handset to the base, the handset ID will be assigned.
1) Before registering the extra handset, the battery pack MUST be charged for 15-
20 hours.
2) With the main base in standby mode, press the soft key on the base.
3) Press on the base to select HS Registering, and then
press the soft key.
4) On the handset, press and hold the key for two seconds.
To cancel registration, press the soft key on the base.
5) While the handset is registering, will appear in the LCD.
When is displayed, the handset has been registered to
the base. If appears, please try these steps again. the base
by following the same steps above.
The WDECT2380 expansion handset can be registered to the base by following
the same steps above.
Place handset on main base to register.
MENU
OK
#/
CANCEL
/volume up/down
Handset Registering
Registration Complete
Registration Failed
[17]