Uniden WDECT 2345+1 - Manual (Page 66)

!
!
!
!
If the recording
memory is full,
appears
in the display. You can
not record a
conversation until you
clear some messages
from the memory.
Every state has
different regulations
governing the
recording of
conversations over
the telephone.
Make sure to check
your local, state and
federal laws before
using this product to
record any telephone
conversation in order
to determine that your
use is in compliance
with such laws or
guidelines.
You can not record
intercom
conversations.
To activate this
feature,you must turn
the Call Screen
feature on. See
“Setting the Call
Screen“ on page 59.
Unavailable
Voice memo
Recording a conversation
Screening a call
The voice memo function allows the user to record messages (more than two
seconds and less than four minutes).
1) With the phone in standby mode, press the soft key on the base.
2) Press the soft key. You will hear the announcement "Record Memo
Message" and a confirmation tone.
3) Start your recording.
4) When you have finished, press the soft key to stop recording.
The system returns to standby.
• The voice memo messages are recorded as an incoming messages.
• When the answering system is full, appears on the display, and
recording is terminated.
You can record a conversation from the handset or the base (more than two
seconds and less than ten minutes).
1) During a conversation, press (or the soft key on the base).
2) Press to select Call Record, and then press
or the soft key on the base). Recording a Call appears on the display.
A confirmation tone that can be heard by both parties sounds during
recording. Use the same procedure to stop recording. Stop Recording appears.
To screen an incoming call, use the following steps:
RECORD
START
STOP
MENU
OK
From the base
menu/del
volume up/down select/
FULL
[65]