Setting up the scanner, Installing the interface cable, Setting up the scanner -5 – Wasp Bar Code Wasp Duraline WLS 8400 FZ User Manual
Page 25: Installing the interface cable -5
Advertising
Getting Started
1-5
Setting Up the Scanner
Installing the Interface Cable
1. Loosen the two screws on the cable clamp at the bottom of the scanner and gently
pull the clamp away from the bottom of the scanner.
2. Open the clamp and plug the interface cable modular connector into the cable
interface port on the bottom of the scanner handle.
3. Gently tug the cable to ensure the connector is properly secured.
Advertising
This manual is related to the following products: