Wasp Bar Code Wasp Duraline WLS 8400 FZ - Manual (Page 92)

WLS 8400 Product Reference Guide 6-4
Connecting an RS-232 Interface
This connection is made directly from the scanner to the host computer.
Figure 6-1. RS-232 Direct Connection
Interface cables vary depending on configuration. The connectors
illustrated in
Figure 6-1 are examples only. The connectors may be
different than those illustrated, but the steps to connect the scanner
remain the same.
1. Attach the modular connector of the RS-232 interface cable to the cable interface
port on the scanner. (See Installing the Interface Cable on page 1-5.)
2. Connect the other end of the RS-232 interface cable to the serial port on the host.
3. Connect the power supply to the serial connector end of the RS-232 interface cable.
Plug the power supply to an appropriate outlet.
4. Ensure that all connections are secure.
5. Select the RS-232 host type by scanning the appropriate bar code from the RS-232
Host Types section on page 6-9 .
6. To modify any other parameter options, scan the appropriate bar codes in this
chapter.
Serial Port Connector to
Interface
Power supply