Yamaha DRX-2 - Manual (Page 24)

19 Connecting an AV receiver
•) Make sure that all necessary connections are made before connecting the DVD
recorder to the power supply.
•) Plug the power cable supplied into the Power connector on the rear of the
recorder.
•) Plug the mains plug into an AC outlet.
•) Switch on the TV set and select the programme number that you have chosen for
video playback (see operating manual for your TV set).
•) Press STANDBY/ON.
– The recorder display lights up. If you have not yet installed your DVD recorder, it
will enter ‘Initial Setup mode.’ In this mode you will have to set your personal
preferences.
Power supply
Note
Always check if the local mains voltage matches the required 100V - 120V.
When the recorder is in the Standby position, it is still consuming some power.
If you wish to disconnect your DVD recorder completely from the mains, withdraw the plug
from the AC Outlet.
Switching on