Yamaha DRX-2 - Manual (Page 62)

57 Programming a recording (TIMER)
Problem solving for programmed
recordings
PROBLEM SOLUTION
The DVD recorder is not responding
✓ While a programmed recording is being made, you cannot operate your DVD
recorder manually. If you want to cancel the programmed recording, press B/I.
“Switch off, timer recording” flashes on the
TV screen.
✓ The DVD recorder was switched on several minutes before the start of a pro-
grammed recording. Switch off the DVD recorder using B/I. A programmed
recording (timer) will only function if the DVD recorder is switched off (B/I but-
ton).
Error message: “Insert recordable disc”
✓ Either a disc has not been inserted or the disc cannot be used for recording. Insert
a disc on which recordings can be made. Switch off the DVD recorder using B/I.
The error message “Disc locked” appears
briefly on the screen. ✓ A write-protected disc has been inserted. Undo the write protection (see “Pre-
venting accidental erasing of discs” in “Manual recording”) or insert a different disc.
Error message:
“Memory full”
✓ If this error message appears after pressing TIMER, then all TIMER blocks are
already programmed. No more recordings can be programmed. Press the u button.
If you want to clear or check a programmed recording (TIMER block), select it with
v or w.
The “Data error” message appears on the
screen.
✓ The data for the recording could not be transferred. Please check date, start time
and end time of the programmed recording.
The “Collision” message appears on the
screen.
✓ Two programmed recordings overlap.
✓ If you ignore this error message the show with the earlier start time will be
recorded first. The start of the second show will not be recorded.
✓ Change the setting for either of the two recordings.
✓ Clear either of the two recordings