Yamaha DRX-2 - Manual (Page 26)

21 Installing your DVD recorder
7 Select the desired screen format position using w or v.
These settings will only be used if you insert a DVD that contains this information.
8
Confirm with ENTER/OK.
9 After you connect the aerial (or cable TV, satellite receiver, etc.) to the DVD
recorder, press ENTER/OK.
The automatic TV channel search starts. “WAIT” will appear on the display.
0 When the automatic TV channel search is complete after several minutes of wait,
“Auto ch. search complete” will appear on the TV screen.
A To remove the menu, press the SYSTEM-MENU button on the recorder’s
remote control.
The initial installation is now complete.
Question
Which screen formats can I select?
“4:3 letterbox” for a “wide-screen” (cinema format) picture with black bars at the
top and bottom.
“4:3 panscan” for a full-height picture with the sides trimmed.
“16:9” for a wide-screen TV set (screen edge ratio 16:9)
Problem
✘ The DVD recorder cannot find any TV stations
✓ Select channel 1 on the TV set. Can you see the stored TV channel on the TV
set?
If not, check the cable connection from the aerial (aerial jack) to the DVD
recorder and to the TV set.
✓ Please have patience.
The DVD recorder searches the entire frequency range in order to find and save
the largest possible number of TV channels.
✓ If you have not connected an aerial, go through all the basic settings right to the
end and then, if you wish, start the automatic search (see “Automatic TV station
search”).
Initial Setup
TV Shape
Press OK to continue
4:3 letterbox
4:3 panscan
16:9
Installation
Auto Ch. Programming
Searching for TV channels
000 Channels found
Please wait