Yamaha htr-5890 - Manual (Page 28)

24
CONNECTIONS
■ Connecting the AC power cord
Plug the power cord into the AC inlet after all other
connections are complete, then plug the power cord to an
AC wall outlet.
Do not use other AC power cords. Use the one provided.
Use of other power cords may result in fire hazard or
electrical shock.
■ AC OUTLET(S) (SWITCHED)
Use outlets to connect the power cords from your other
components to this unit. Power to the AC OUTLET is
controlled by this unit’s STANDBY/ON (or SYSTEM
POWER and STANDBY). These outlets will supply
power to any connected component whenever this unit is
turned on. The maximum power (total power consumption
of components) that can be connected to the AC OUTLET
is 100 W.
■ Memory back-up
The memory back-up circuit prevents the stored data from
being lost even if this unit is in the standby mode.
However if the power cord is disconnected from the AC
wall outlet, or the power supply is cut for more than one
week, the stored data will be lost.
Connecting the power supply cord
AC OUTLETS
CAUTION
01EN00_HTR5890U.book Page 24 Thursday, December 23, 2004 12:39 PM