Yamaha htr-5890 - Manual (Page 72)

68
REMOTE CONTROL FEATURES
8
Press one of the buttons shaded below to
see if you can control your component. If you
can, the remote control code is correct.
y
If the manufacturer of your component has more than one
code, try each of them until you find the correct one.
• “ERROR” appears in the display window if you press a button
not indicated in the respective step, or when you press more
than one button simultaneously.
• The supplied remote control does not contain all possible codes
for commercially available audio and video components
(including YAMAHA components). If operation is not possible
with any of the remote control codes, program the new remote
control function using the Learn feature (see “Programming
codes from other remote controls (Learn)”) or use the remote
control supplied with the component.
• Function programmed using the learn feature take priority over
remote control code functions.
Use the Learn feature if you want to program functions
not included in the basic operations covered by remote
control codes, or an appropriate remote control code is not
available. You can program any of the buttons available in
the component control area (see page 65). The buttons can
be programmed independently for each component.
This remote control transmits infrared beams. If the other remote
control also uses infrared beams, this remote control can learn
most of its functions. However, you may not be able to program
some special signals or extremely long transmissions. (Refer to
the operating instructions for the other remote control.)
1
Set AMP/SOURCE/TV to SOURCE.
2
Press an input selector button to select a
source component.
3
Place this remote control about 5 to 10 cm
(2 to 4 in) apart from the other remote control
on a flat surface so that their infrared
transmitters are aimed at each other.
Notes
CLEAR LEARN RE–NAME
FREQ/RDS EON MODE PTY SEEK START
REC
DISC SKIP
THX STANDARD EXTD. SUR
9 0 +10 ENT.
MACRO ON OFF
TRANSMIT
DTV DVR/VCR2 VCR 1 DVD
V-AUX CBL/SAT MD/TAPE CD-R
PHONO TUNER CD MULTI CH IN
POWER POWER POWER
SYSTEM
STANDBY
AV TV
SLEEP INPUT MODE A B
Programming codes from other
remote controls (Learn)
Note
AMP
SOURCE
TV
DTV DVR/VCR2 VCR 1 DVD
V-AUX CBL/SAT MD/TAPE CD-R
PHONO TUNER CD MULTI CH IN
SLEEP INPUT MODE A B
TRANSMIT
SELECT
DTV
D VR/VCR2
VCR 1
DV
D
V -AU
X
CBL/SA
T
MD/T
APE
CD-R
PHONO
TUNER
CD
MUL
TI CH IN
PO
WER
PO
WER
PO
WER
SYSTEM
ST ANDBY
AV
TV
SLEEP
INPUT MODE
A
B
5 to 10 cm (2 to 4 in)
01EN00_HTR5890U.book Page 68 Thursday, December 23, 2004 12:39 PM