Yamaha htr-5890 - Manual (Page 77)

73
REMOTE CONTROL FEATURES
A
D
V
ANCED
OPERA
T
ION
4
Press the buttons for the functions you want
to include in the macro operation in
sequence.
You can set up to 10 steps (10 functions). After you
have set 10 steps, “FULL” appears and the remote
control automatically exits the macro mode.
• The macro operation may not work for a component
which takes time to start up.
• To change the selected source component, press SELECT k/
n . Pressing the input selector buttons will program a macro
step, whereas SELECT k/n only changes the selected
component and corresponding component control area.
5
Press MACRO again when the operation
sequence you want to program is complete.
“ERROR” appears in the display window if you press a
button not indicated in the respective step, or if you press
more than one button simultaneously.
You can clear all changes made in each function set, such
as learned functions, renamed source names and setup
remote control codes.
1
Set AMP/SOURCE/TV to AMP or SOURCE.
2
Press CLEAR by using a ballpoint pen or
similar object.
“CLEAR” appears in the display window.
If you do not complete each of the following steps within 30
seconds, the clearing mode will be automatically canceled.
In this case, press CLEAR again.
3
Press k / n to select the clear mode.
L:DVD (L: name of a component)
Clears all learned functions in the respective
component control area. Press an input selector
button to select the component.
L:AMP Clears all learned functions for this unit’s control
area.
L:ALL Clears all learned functions.
M:ALL Clears all programmed macros
RNAME Clears all renamed source names.
FCTRY Clears all remote functions and returns the remote
to the factory settings.
4
Press and hold CLEAR again for about 3
seconds.
“WAIT” appears in the display window. If clearing
was successful, “C:OK” appears in the display
window.
y
Once you have cleared a learned function for a button, the
button reverts to the factory setting (or to the manufacturer
setting, if you have set remote control codes).
“L:ALL” and “FCTRY” may take about 30 seconds to
complete.
Note
Note
Memory back-up
If the remote control is without batteries for more than
2 minutes, or if exhausted batteries remain in the
remote control, the contents of the memory may be
cleared. If the memory is cleared, insert new batteries,
set up the remote control code(s) and program any
acquired functions that may have been cleared.
DTV DVR/VCR2 VCR 1 DVD
V-AUX CBL/SAT MD/TAPE CD-R
PHONO TUNER CD MULTI CH IN
POWER POWER POWER
SYSTEM
STANDBY
AV TV
SLEEP INPUT MODE A B
CLEAR LEARN RE–NAME
FREQ/RDS EON MODE PTY SEEK START
REC
DISC SKIP
MACRO ON OFF
1
2
3
MCR 1: DVD
Indicates the
number of macro
steps entered
Flashes alternately so you can
set the next step
MCR 2: AV POWER
MCR 3: h
Clearing function sets
Note
Note
AMP
SOURCE
TV
CLEAR
CLEAR
01EN00_HTR5890U.book Page 73 Thursday, December 23, 2004 12:39 PM