Yamaha htr-5890 - Manual (Page 33)

29
AUTO SETUP
PRE
P
ARA
T
ION
■ Troubleshooting for auto setup procedure
Before auto setup
During auto setup
Press l / h to display the detailed information about individual errors. Select “RETRY” to try auto setup procedure
again.
Error message Cause Remedy
Connect MIC! Optimizer microphone is not connected. • Connect the supplied optimizer microphone to the
OPTIMIZER MIC jack on the front panel.
Unplug HP! Headphones are connected. • Unplug the headphones.
Error message Cause Remedy
E-1:NO FRONT SP Front L/R channel signal(s) is (are) not
detected. • Select the front speakers with SPEAKER A or B.
• Check the front L/R speaker connections.
E-2:NO SURR.SP A surround channel signal is not detected. • Check the surround speaker connections.
E-3:NO PRES. SP A presence channel signal is not detected. • Check the presence speaker connections.
E-4:SBR->SBL Only right surround back channel signal is
detected. • Connect the surround back speaker to the LEFT
SURROUND BACK SPEAKERS terminal if you
only have one surround back speaker.
E-5:NOISY Background noise is too loud. • Try auto setup procedure in a quiet environment.
• Turn off noisy electric equipment like air conditioners
(etc.) or move them away from the optimizer
microphone.
E-6:CHECK SURR. Surround back speaker(s) is (are) connected,
though surround L/R speakers are not. • Connect surround speakers when you use (a)
surround back speaker(s).
E-7:NO MIC The optimizer microphone was unplugged
during the auto setup procedure. • Connect the supplied optimizer microphone to
OPTIMIZER MIC jack on the front panel.
E-8:NO SIGNAL The optimizer microphone does not detect test
tones. • Check the microphone setting.
• Check the speaker connections and placement.
E-9:USER CANCEL The auto setup procedure was cancelled due to
user activity. • Perform the auto setup procedure again.
E-10:OTHER ERROR An internal error occurred. • Perform the auto setup procedure again.
01EN00_HTR5890U.book Page 29 Thursday, December 23, 2004 12:39 PM