Zebra Technologies XiII-Series - Manual (Page 42)

Changing Password-Protected Parameters
Certain parameters are password-protected by factory default.
CAUTION: Do not change password-protected parameters unless
you’re sure you know what you’re doing! If they are
set incorrectly, these parameters could cause the
printer to function in an unpredictable way.
The first attempt to change one of these parameters (pressing one of the
black oval keys) will require you to enter a four-digit password. This is
done via the “ENTER PASSWORD” display. The left black oval key
changes the selected digit position. The right black oval key increases the
selected digit value. After entering the password, press the Next/Save key.
The parameter you are trying to change will be displayed. If the password
was entered correctly, you can now change the value.
The default password value is 1234. The password can be changed using
the ^KP (Define Password) ZPL II instruction.
NOTE: Once the password has been entered correctly, it will not have to
be entered again unless you leave and re-enter the programming
mode using the Setup/Exit key.
NOTE: You can disable the password protection feature so that it no
longer prompts you for a password by setting the password to
ШШШШ via the ^KPØ ZPL/ZPL II command. To re-enable the
password-protection feature, send the ZPL/ZPL II command
^KPx, where “x” can be any number, 1-4 digits in length,
except Ø.
30 Zebra XiII-Series User’s Guide
42
H:...Xi2UsersGuideR2.vp
Fri Aug 07 10:35:48 1998
Color profile: Disabled
Composite Default screen