Xantrex Technology DR1524W - Manual (Page 36)

Installation
2–12 975-0012-01-02 Rev A
3. Secure the 2 x 4 with #10 wood screws (length to penetrate 1½ inches into the
studs) as shown in Figure 2-7.
4. Measure 7 5/8" from the center of the first 2 x 4 and draw another level line.
Place the center of the second 2 x 4 over this line and secure to the wall as
described in Step 5.
5. Using the dimensions illustrated in Figure 2-6, drill mounting holes into the
center of the 2 x 4’s for the inverter.
6. Secure the inverter to the 2 x 4’s using ¼ x 1½ inch lag bolts and washers.
Figure 2-7 Suggested Mounting Method
Figure 2-8 Mounting on Plywood
Ensure the plywood spans
across a minimum of three wall
studs for adequate support.