Yamaha RX-V1800 - Manual (Page 45)

41
En
Optimizing the speaker setting for your listening room
PRE
P
ARA
T
ION
English
■ If an error screen appears
Press 3l / h to select “RETRY” or “EXIT” and
then press 3
ENTER.
The following display is an example where “E-9:USER
CANCEL” appears in the OSD.
Choices: RETRY, EXIT
• Select “RETRY” to retry the “AUTO SETUP”
procedure.
• Select “EXIT” to exit from the “AUTO SETUP”
procedure.
y
• If “E-5:NOISY” appears in the OSD, you can also select
“PROCEED” and let this unit continue the automatic setup.
However, we recommend that you perform the automatic setup
procedure again for more accurate adjustment.
• If “E-10:INTERNAL ERROR” appears in the OSD, you can
select only “EXIT”.
• For details about each error message, refer to the “AUTO
SETUP” section in “Troubleshooting” on page 128.
■ If “WARNING” appears
When this unit detects potential problems during the
automatic setup procedure, “WARNING” appears in the
result display. Check the warning messages to correct your
speaker settings.
Warnings differ from errors in that warnings do not cancel the
“AUTO SETUP” procedure.
1
Make sure the pointer is pointing at
“WARNING” and then press 3
ENTER to
display the detailed information about the
warning.
The number on the right of “WARNING” indicates
the number of warning messages.
2
Press 3l / h repeatedly to toggle between
the warning displays.
y
• For details about each warning message, refer to the
“AUTO SETUP” section in “Troubleshooting” on
page 128.
• When the corresponding warning message is not
applicable to a speaker, “– – –” is displayed instead.
• If the volume level setting of the connected subwoofer is
too high or low, “TOO LOUD” (the volume level setting is
too high) or “TOO LOW” (the volume level setting is too
low) is displayed in the “W-3:LEVEL ERROR” display.
Adjust the volume level setting of the connected
subwoofer appropriately.
3
Press 3
ENTER to return to the top result
display.
y
The adjustment are made even if “WARNING” appears, however
the adjustment may not be optimal.
Note
[p]/[[]:
[ENTER]:
ERROR
E-9:USER CANCEL
Don't operate
any function
>RETRY EXIT
Select
Enter
.
[p]/[[]:
[ENTER]:
ERROR
E-5:NOISY
Keep silent
>RETRY EXIT PROCEED
Select
Enter
.
[ ]/[ ]:
[ENTER]:
[ p
AUTO SETUP
WARNING 2
RESULT
SP : 5/4/0.1
DIST: 14.0/17.0ft
LVL : -10.0/+5.0dB
>SET CANCEL
UP/DOWN
Detail
.
[p]/[[]:
[ENTER]:
WARNING
W-1:OUT OF PHASE
Reverse channel
FL ---
CENTER
--- PR
SL ---
SBL ---
Select
Return
[p]/[[]:
[ENTER]:
WARNING
W-3:LEVEL ERROR
--- FR
CENTER
PL ---
--- SR
--- SBL
SWFR:TOO LOUD
Select
Return