Yamaha RX-V1800 - Manual (Page 84)

80
En
Customizing this unit (MANUAL SETUP)
Use this feature to manually adjust the basic speaker
settings. Most of the “BASIC MENU” parameters are set
automatically when you run the automatic setup.
y
Set “TEST TONE” to “ON” to output the test tone for the
“SPEAKER SET”, “SPEAKER LEVEL” and “SP DISTANCE”.
■ Speaker settings
A)SPEAKER SET
LFE/bass out LFE/BASS OUT
Use this feature to select the speakers that output the LFE
(low-frequency effect) and the low-frequency signals.
Choices: SWFR, FRONT, BOTH
When a subwoofer is connected to this unit
and you want to get natural bass sound:
Select “SWFR” (subwoofer). The LFE signals as well
as the low-frequency signals of other speakers set to
“SML” (or “SMALL”) are directed to the subwoofer.
When a subwoofer is connected to this unit
and you want to get rich bass sound:
Select “BOTH” (both). The low-frequency signals of
any source are output from the subwoofer. The LFE
signals as well as the low-frequency signals of other
speakers set to “SML” (or “SMALL”) are directed to
the subwoofer. The low-frequency signals of the front
left and right channels are directed to the front left and
right speakers and the subwoofer regardless of the
“FRONT SP” setting.
When you do not use a subwoofer:
Select “FRONT” (front). The LFE signals, the
low-frequency signals of the front left and right
channels, and the low-frequency signals of other
speakers set to “SML” (or “SMALL”) are all directed
to the front left and right speakers regardless of the
“FRONT SP” setting.
Front speakers FRONT SP
Choices: SMALL, LARGE
When the front speakers are large:
Select “LARGE” (large).
When the front speakers are small:
Select “SMALL” (small).
• When “LFE/BASS OUT” is set to “FRONT”, the LFE signals
found in bitstream sources, the low-frequency signals of the
front left and right channels, and the low-frequency signals of
other speakers set to “SML” (or “SMALL”) are all directed to
the front left and right speakers regardless of the “FRONT SP”
setting.
• When “LFE/BASS OUT” is set to “FRONT”, you can select
only “LARGE” in “FRONT SP”. If the value of “FRONT SP” is
set to other than “LARGE” in advance, this unit change the
value to “LARGE” automatically.
Center speaker CENTER SP
Choices: NONE, SMALL, LARGE
When the center speaker is large:
Select “LARGE” (large).
When the center speaker is small:
Select “SMALL” (small).
When you do not use the center speaker:
Select “NONE” (none). The center channel signals are
directed to the front left and right speakers.
1 BASIC MENU
[ ]/[ ]:
[ENTER]:
[ p
1 BASIC MENU
A)SPEAKER SET
B)SPEAKER LEVEL
C)SP DISTANCE
D)TEST TONE
UP/DOWN
Enter
.
A)SPEAKER SET
LFE/BASS OUT
SWFR FRONT>BOTH
Measure for the speaker size
The woofer section of a speaker is
– 16 cm (6.5 in) or larger: large
– smaller than 16 cm (6.5 in): small
Notes
A)SPEAKER SET
FRONT SP
SMALL >LARGE
A)SPEAKER SET
CENTER SP
NONE >SMALL LARGE