Zebra Technologies Z SERIES 79695L-002 - Manual (Page 128)

Troubleshooting
Miscellaneous Printer Problems 128
79695L-002 Rev. A Z Series ® /RZ™ Series User Guide 6/6/08
Miscellaneous Printer Problems
Table 22 identifies miscellaneous problems with the printer, the possible causes, and the
recommended solutions.
Table 22 • Miscellaneous Printer Problems
Problem Possible Cause Recommended Solution
The LCD displays a
language that I
cannot read The language parameter was
changed through the control
panel or a firmware command. 1. Press SETUP/EXIT to enter configuration
mode.
2. Press MINUS (-) .
The printer displays the LANGUAGE
parameter in the current language. Even if
you cannot recognize the characters
displayed, you can still scroll to another
language.
3. Press SELECT to select the parameter.
4. Press PLUS (+) or MINUS (-) to scroll
through the choices until you find a language
that you can read.
5. Press SETUP/EXIT .
The LCD displays SAVE CHANGES in the
original language.
6. Press SETUP/EXIT again to exit
configuration mode and save the changes
(if the language does not change, you may
need to scroll to a different save option by
pressing
PLUS (+) or MINUS (-) in the
previous step).
7. Repeat this process, if necessary, until you
reach the desired language.
The LCD is missing
characters or parts of
characters The LCD may need replacing. Call a service technician.