Zebra Technologies Z SERIES 79695L-002 - Manual (Page 89)

89 Configuration
Standard Control Panel Parameters
6/6/08 Z Series ® /RZ™ Series User Guide 79695L-002 Rev. A
Select Media Power-Up Option
This parameter sets the action of the media when you turn on the printer.
Default Value (non-RFID printers): CALIBRATION
Default Value (RFID printers): FEED
Selections: CALIBRATION, SHORT CAL, LENGTH, NO MOTION,
FEED
• Calibration adjusts sensor levels and thresholds, determines length,
and feeds the media to the next web.
• Short Cal sets media and web thresholds without adjusting sensor
gain, determines length, and feeds the media to the next web.
• Length determines label length using current sensor values, and feeds
the media to the next web.
• No Motion tells the printer not to move the media. You must
manually ensure that the web is positioned correctly, or press feed to
position the next web.
• Feed—feeds the labels to the first registration point.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Select Head Close Option
This parameter sets the action of the media when you close the printhead.
Default Value (non-RFID printers): CALIBRATION
Default Value (RFID printers): FEED
Selections: CALIBRATION, SHORT CAL, LENGTH, NO MOTION,
FEED
• Calibration adjusts sensor levels and thresholds, determines length,
and feeds the media to the next web.
• Short Cal sets media and web thresholds without adjusting sensor
gain, determines length, and feeds the media to the next web.
• Length determines label length using current sensor values, and feeds
the media to the next web.
• No Motion tells the printer not to move the media. You must
manually ensure that the web is positioned correctly, or press feed to
position the next web.
• Feed—feeds the labels to the first registration point.
To change the value shown:
1. Press SELECT to select the parameter.
2. Press PLUS (+) or MINUS (-) to scroll through the options.
3. Press SELECT to accept any changes and deselect the parameter.
Table 12 • Printer Parameters (Page 21 of 26)
Language/Parameter Action/Explanation