Zebra Technologies Z SERIES 79695L-002 - Manual (Page 153)

153 Index
6/6/08 Z Series ® /RZ™ Series User Guide 79695L-002 Rev. A
printhead
cleaning, 104
faulty thermistor, 116
head close setting, 89
invalid replacement head error, 115
pressure adjustment, 61
printing specifications, 143
programming position
set through calibration or reset to default, 97
protocol setting, 86
R
radiation exposure limits, 4
read power
change through control panel, 97
read/write position
set through calibration or reset to default, 97
recycling printer parts, 102
registration problems, 122
relative humidity requirements, 26
remove used ribbon, 59
replacement parts, 102
report shipping damage, 25
reprint mode for reprinting last label, 91
reset programming position, 97
restore
factory default settings, 65
network settings, 65
Rewind mode
adjust media alignment, 112
liner removal, 110
loading media, 41
media path, 40
print mode use described, 38
selecting, 72
RFID
calibrate RFID tag from control panel, 97
change read power through control panel, 97
change write power through control panel, 98
display tag data, 99
error status, 98
firmware and language restrictions, 22
printer parameters, 95
RFID test, 96
“smart” labels, 33
troubleshooting, 125
ribbon
adhesive test, 35
determining coated side, 35
loading, 55
ordering, 11
removing, 59
ribbon LED setting, 92
scratch test, 36
specifications, 146
when to use, 35
RIBBON IN message, 116
RIBBON OUT message, 115
Ribbon S. setting, 92
ribbon sensor
calibration procedure, 83
print sensor profile, 82
roll media
described, 33
loading, 42
routine cleaning schedule, 103
RTC (real-time clock) setting
date, 93
idle display, 93
time, 93
S
sales, 11
scratch test
media type, 35
ribbon coated side, 36
self tests, 131
CANCEL, 132
communications diagnostics, 138
FEED, 134
FEED and PAUSE, 137
PAUSE, 133
Power-On Self Test (POST), 131
sensor profile calibration
selecting through control panel, 82
sensors
cleaning, 107
interpreting sensor profile, 139
print sensor profile, 82
serial port
characteristics of serial connection, 27
connection and configuration, 29
connector location, 17
setting serial communications, 84
setup
checklist, 24
unpack the printer, 25