Setup mode, Enter and use setup mode – Zebra Technologies Z SERIES 79695L-002 User Manual

Page 64

Advertising
background image

Configuration
Setup Mode

64

79695L-002 Rev. A

Z Series

®

/RZ™ Series User Guide

6/6/08

Setup Mode

After you have installed the media and ribbon and the Power-On Self Test (POST) is complete,
the control panel displays

PRINTER READY

. You may now set printer parameters for your

application using the control panel display and the buttons directly below it. If it becomes
necessary to restore the initial printer defaults, see

FEED and PAUSE Self Test on page 137

.

Enter and Use Setup Mode

Use the LCD on the control panel to view and adjust printer settings through Setup mode.
When a parameter is changed, an asterisk (*) appears in the upper left corner of the display to
indicate that the value is different from the one currently active in the printer.

Important •

Certain printing conditions may require that you adjust printing parameters,

such as print speed, darkness, or print mode. These conditions include (but are not
limited to):

• printing at high speeds

• peeling the media

• the use of extremely thin, small, synthetic, or coated labels

Because these and other factors affect print quality, run tests to determine the best
combination of printer settings and media for your application. A poor match may limit print
quality or print rate, or the printer may not function properly in the desired print mode.

Press this key...

To do the following...

SETUP/EXIT

enter or exit Setup mode.

SELECT

select or deselect a parameter.

PLUS (+)

continue to the next parameter.

MINUS (-)

return to the previous parameter in the cycle.

Advertising