Zebra Technologies ZEBRA QL UMAN-QLP-001 - Manual (Page 30)

30
QL Plus Series User Guide
the cable must be plugged into the host terminal as shown in
Figure 12, or to a serial or USB port on a computer (Figure 13.)
The QL Plus series is configured with the USB Open HCI inter-
face driver allowing it to communicate with Windows
® based
devices.
USB drivers are included in the Zebra Universal Driver which
can be downloaded from the Zebra Web site. Other terminals
or communications devices may require the installation of
special drivers to use the USB connection. Consult the factory
for further details.
Providing Strain Relief for Communications Cable
If you are connecting a communications cable to the print-
er permanently, use the strain relief features built into the belt
clip retainer to prevent excessive strain on the communica-
tions connector. There are two kinds of strain relief features.
If you are using the printer with the standard belt clip, bend
the cable in a broad loop to relieve stress on the connector
and press it into the retaining feature on the belt clip retainer
as shown in figure 14.
Figure 14: Communications Strain Relief
Press communications
cable into strain relief
feature on Belt Clip