Zebra Technologies ZEBRA QL UMAN-QLP-001 User Manual
Page 44
44
QL Plus Series User Guide
Compact Flash (802.11b) and Bluetooth Co-located Radio
Modules
The following section only applies when the CF (Compact Flash) WLAN module ( FCC ID: H9PLA4137) and
Bluetooth module (FCC ID: I28MD-BTC2TY4) are installed in a QL 220 Plus or QL 420 Plus printer. This co-
located radio configuration has demonstrated compliance to FCC regulations. The FCC ID numbers are on
the serial number label on the back of the printer and can be read with the module installed.
Caution • Use of a QL 220 Plus or QL 420 Plus printer with
the radio module marked with both “FCC ID: H9PLA4137” and
“I28MD-BTC2TY4” meets the FCC requirements for radio frequency
(RF) radiation exposure in the standard body worn configuration with
no minimum separation. In this configuration, which applies whether
the belt clip or shoulder strap is used, the face of the printer from
which paper is transported is facing away from the user’s body. The
standard configuration must always be used when the printer is body
worn. QL 220 Plus and QL 420 Plus printers with this radio option
have been SAR tested. The maximum measured SAR values are listed
below.
Model
SAR value W/Kg (1g average)
)
QL220 Plus
0.01
QL 420 Plus
0.39
European Regulatory Information for Co-located Radios
AT
BE
CY
CZ
DK
EE
FI
FR
DE
GR
HU
IE
IT
LV
LT
LU
MT
NL
PL
PT
SK
SI
ES
SE
GB
Note: -Member states in the EU with restrictive use for this device are crossed
out!
This device is also authorized for use in all EFTA member states (
CH, IS, LI, NO)
Important Notice:
This device is a portable RF printer intended
for commercial and industrial use in all EU and
EFTA member states except in France where
restrictive use applies.