Xilinx IP Ethernet AVB Endpoint v2.4 UG492 - Manual (Page 122)

122 www.xilinx.com Ethernet AVB Endpoint User Guide
UG492 September 21, 2010
Chapter 12: System Integration
In this example, the instance of the Ethernet AVB Endpoint core should be assigned a base
address in the Microprocessor Hardware Specification (.mhs) file, to match that of the
Ethernet AVB Endpoint
“PLB Base Address” (in the generated netlist produced by the
CORE Generator software). Then the AVB software drivers can be assigned to this instance
in the Microprocessor Software Specification (.mss) file.
Using an ISE Software Top-Level Project
X-Ref Target - Figure 12-7
Figure 12-7: Connection into an Embedded Processor Sub-system with an ISE Software Top-Level Project
Microblaze
BRAM
xps_intc xps_uartlite
lmb_bram_if_cntlr
Ethernet
AVB
Endpoin t
TEMAC
Custom AV logic
Custom Legacy logic
PLB
PLB
AV
traffic
I/F
Legacy
traffic
I/F
MAC
client
I/F
Host I/F MDIO
Ethernet
PHY I/F
interrupt_ptp_timer
interrupt_ptp_rx
interrupt_ptp_tx
pcore:
plb_port
EDK tool domain
ISE tool domain