Yamaha M7CL-32 - Manual (Page 19)

Top panel
P
anels and controls
19
M7CL Owner’s Manual
2
If an optional MBM7CL meter bridge is installed, the
MIX/MATRIX channel levels can be monitored at all
times. The monitoring position can be selected from PRE
EQ (immediately before attenuator), PRE FADER (imme-
diately before the fader), or POST ON (immediately after
the [ON] key). 1 MIX meters
These indicate the level of MIX channels 1–16.
B MATRIX meters
These indicate the level of MATRIX channels 1–8.
In this section you can control the mix parameters for the
currently selected input channel or output channel.
1 [MIX/MATRIX] encoders
●
When an input channel is selected
This adjusts the send level of the signal sent from that
channel to the MIX/MATRIX buses.
● When a MIX/STEREO/MONO channel is
selected
This adjusts the send level of the signal sent from the
selected MIX/STEREO/MONO channel to the
MATRIX buses.
● When a MATRIX channel is selected
This adjusts the send level of the signal sent from each
MIX channel to the selected MATRIX bus.
●
When SENDS ON FADER mode
Push in an encoder to select the corresponding destina-
tion bus.
B [HA] encoder
Adjusts the head amp gain of an input channel. This does
nothing if another type of channel is selected.
C [PAN] encoder
●
When an input channel is selected
This adjusts the panning of the signal that is sent from
the selected channel to the L/R channels (or L/C/R
channels) of the STEREO bus.
●
When a ST IN channel is selected
This adjusts the left/right balance of the signals that
are sent from the selected two channels to the STE-
REO bus.
● When a MIX channel (MONO x 2) is selected
This adjusts the panning of the signal that is sent from
the selected channel to the L/R channels of the STE-
REO bus.
● When a MIX channel (STEREO) is selected
This adjusts the left/right balance of signals that are
sent from the two selected channels to the L/R chan-
nels of the STEREO bus or the left/right balance of the
output signals.
●
When a MATRIX channel (MONO x 2) is
selected
This encoder will be disabled.
● When a MATRIX channel (STEREO) is selected
This adjusts the left/right balance of signals that are
output from the two selected channels.
● When a STEREO channel is selected
This adjusts the left/right balance of the signals that
are output from the L/R channels of the STEREO bus.
■ Meter bridge (option)
1 2
■ SELECTED CHANNEL section
4
5
6
7
1 2 3
• If the SIGNAL TYPE of the destination bus is set to STEREO,
use the left encoders to adjust PAN and the right encoders to
adjust the send level.
NOTE
• The PAD will be internally switched on or off when the HA gain is
adjusted between -14 dB and -13 dB. Keep in mind that noise may
be generated if there is a difference between the Hot and Cold
output impedance of the external device connected to the INPUT
connector when using phantom power.
NOTE
• You can link this setting to the PAN setting for signals sent to
a MIX or MATRIX for which the BUS TYPE is set to STEREO.
(
→ p. 234)
NOTE