Yamaha M7CL-32 User Manual

Page 199

Advertising
background image

Basic MIDI settings

M7CL Owner’s Manual

MIDI

17

199

F

CONTROL CHANGE field

Here you can make settings for control change trans-
mission/reception.

• Tx button

........Switches control change transmis-

sion on/off.

• Rx button

.......Switches control change reception

on/off.

• ECHO button

...........Selects whether incoming control

changes will be echoed out from the
MIDI transmit port.

G

CONTROL CHANGE MODE field

Here you can select the control change transmission/
reception mode.

• NRPN button

...........If this button is on, the M7CL’s mix

parameters will be transmitted/
received as NRPN messages on
one MIDI channel (NRPN mode).

• TABLE button

...........If this button is on, the M7CL’s mix

parameters will be transmitted/
received as control change mes-
sages on one MIDI channel (TABLE
mode).

H

PARAMETER CHANGE field

Here you can make settings for transmission/reception
of “parameter change” system exclusive messages.

• Tx button

........Switches parameter change trans-

mission on/off.

• Rx button

.......Switches parameter change recep-

tion on/off.

• ECHO button

...........Selects whether incoming parame-

ter changes will be echoed out from
the MIDI transmit port.

I

OTHER COMMAND field

Here you can specify how MIDI messages other than
program changes, control changes, and parameter
changes (i.e., messages such as note-on/off and MIDI
timing clock) will be received.

• ECHO button

...........Selects whether other MIDI mes-

sages that are received will be ech-
oed out from the MIDI transmit port.

4

To specify the port that will be used to
transmit or receive each type of MIDI mes-
sage, press the transmit (Tx) or receive (Rx)
port select popup button.

The MIDI SETUP popup window for selecting the
port will appear. Operations in this window are the
same for both transmission (Tx) and reception (Rx),
and include the following items.

1

TERMINAL field

Select the port that will transmit or receive MIDI mes-
sages.

You can choose from the following items.

• REMOTE connector settings

B

PORT NO. field

If you select SLOT 1–3 in the TERMINAL field,
choose port number 1–8 in this field. (The number of
available ports will depend on the card that is
installed.)

The currently available card is valid only for port 1.

5

Specify the type of port and the port num-
ber.

Use the

/

buttons to select an item. Press the OK

button to confirm the selected port and close the MIDI
SETUP popup window.

Item

Explanation

NONE

No port will be used.

MIDI

Rear panel MIDI IN (Rx) / OUT (Tx) connector

REMOTE
(M7CL-32/48)

Rear panel REMOTE connector

SLOT 1–3

A card that supports serial transmission,
installed in a rear panel slot 1–3

Format

RS422

Baud rate

38400 bps

Data length

8bit

Stop bit

1

Parity

none

Flow control

none

1

2

• To transmit and receive MIDI messages to and from an exter-

nal controller that features an RS422 connector, select
REMOTE and connect the REMOTE connector to the exter-
nal controller.

• Refer to the pin assignment table for information on pin

assignments.(

p. 298)

NOTE

• Alternatively, you can select a port by pressing the desired

port name in the field, or by pressing the field to highlight it
and then turning one of the multifunction encoders to select
the port.

HINT

Advertising
This manual is related to the following products: