Yamaha M7CL-32 - Manual (Page 82)

M7CL Owner’s Manual 82
6
If you want to enter a channel name directly
(or edit the sample name that was entered),
press the channel name field in the upper
part of the window.
The keyboard window will appear in the lower part of
the window, allowing you to enter or edit the charac-
ters. For details on how to use the keyboard window,
refer to p. 34.
7
Use the [SEL] keys of the Centralogic sec-
tion to switch output channels, and specify
the icon or channel name for other chan-
nels in the same way.
When the PATCH / NAME popup window is shown,
you can use the [SEL] keys of the Centralogic section
to switch channels within the currently selected eight
channels.
If you want to operate output channels other than those
in the currently selected eight channels, use the navi-
gation keys
→
Centralogic section [SEL] keys to
select the desired channel.
8
When you’re finished with your input, press
the “
×
” symbol in the upper right of the win-
dow.
This section explains how to send the signal of a MIX channel to the STEREO bus or MONO
bus.
There are two ways to send signals from a MIX channel to the STEREO bus or MONO bus; ST/
MONO mode and LCR mode. You can select the mode individually for each channel. These
modes differ in the following ways.
This mode sends the signal from the MIX channel to the STEREO bus and to the MONO bus independently.
• The signal sent from the MIX channel to the STEREO bus and to the MONO bus can be switched on/off individually.
• The panning of the signal sent from a monaural MIX channel to the STEREO bus L/R is controlled by the TO ST PAN
knob. (The signal sent to the MONO bus is not affected by this knob.)
• The left/right volume balance of the signal sent from a stereo MIX channel to the STEREO bus is controlled by the
BALANCE knob. (The signal sent to the MONO bus is not affected by this knob.)
This mode sends the signal of the MIX channel to a total of three buses (STEREO (L/R) and MONO (C)) together.
• The signal sent from the MIX channel to the STEREO (L/R) bus and MONO (C) bus will be switched on/off as a whole.
• The CSR (Center Side Ratio) knob specifies the level ratio between the signal sent from the MIX channel to the STE-
REO (L/R) bus and to the MONO (C) bus.
• The TO ST PAN knob / BALANCE knob specifies the level of the signal sent from the MIX channel to the STEREO (L/R)
bus and MONO (C) bus.
Sending signals from MIX channels to the STEREO/MONO bus
■ ST/MONO mode
■ LCR mode
• If you want to monitor the signal of the STEREO bus or MONO bus through headphones etc., you should press
the MONITOR button in the function access area to select “LCR” as the monitor source before you continue with
the following procedure (
→ p. 154).
HINT
Specifying the channel name and icon • Sending signals from MIX channels to the STEREO/MONO bus