Xantrex Technology XPR 150-40 - Manual (Page 27)

Release 1.1 25
Section 2. Installation
Overview
Section 2 provides recommendations and procedures for inspecting, installing, and
testing the power supply. For more information about controls and connectors, refer
to the front panel diagram (
Figure 1.1 ) as well as the rear panel diagram ( Figure 1.3 )
in Section 1 .
Basic Setup Procedure
Table 2.1 provides a summary of the setup procedure and an overview of the
subsections in this chapter. Use this table as a quick reference if you are familiar with
the installation requirements for the power supply. If you require more information,
each step in the table refers to a subsequent section which contains more details.
Complete each step in the sequence given.
Table 2.1 Basic Setup Procedure
Step # Description Action Reference
1 Inspection Visually inspect the power supply. “Inspection, Cleaning, and
Packaging” on page 26
2 Installation Install the power supply, ensuring
adequate ventilation. “Location, Mounting, and
Ventilation” on page 29
3 Input Power Connect AC input power. “AC Input Power” on page 32
4 Test Perform functional tests for voltage
mode operation, current mode
operation, and front panel controls. “Basic Tests” on page 35
5 Select Wires Select wires that can tolerate the DC
current output. “Load Wiring” on page 39
6 Connect Load Connect the load wires to the DC output. “Load Connections” on page 41
7 Connect Remote
Sensing (if required) Connect remote sensing connectors on
power supply to load. “Remote Sensing” on page 45