Roll media loading, Zebra z 4m printer user’s guide 23 – Zebra Technologies ZEBRA Z4M H-974 User Manual

Page 16

Advertising
background image

H-974

PAGE 16 OF 57

0808 IH-974

Roll Media Loading

Tear-Off Mode

Refer to Figure 14.

1.

Press the printhead open lever. The printhead assembly springs up.

2.

Flip down the media supply guide.

3.

Slide out the media guide as far from the printer frame as possible.

4.

Place the roll of media on the media supply hanger.

5.

Flip up the media supply guide. Slide in the media supply guide so that it just
touches, but does not restrict, the edge of the roll.

6.

Feed the media under the dancer, through the slot in the transmissive sensor,
under the ribbon sensor, and out the front of the printer.

7.

Ensure that the media is against the back of the transmissive sensor. Slide in the
media guide so that it just touches, but does not restrict, the edge of the media.

8.

Close the printhead assembly.

22

Zebra Z4M Printer User’s Guide

Zebra Z4M Printer User’s Guide

23

Printhead open lever

Printhead

assembly

Media supply guide

Media guide

Ribbon

sensor

Dancer

Transmissive

sensor

Media

supply

hanger

Figure 14

Advertising