Leaving the setup mode, H-974, Load defaults -- loads factory defaults – Zebra Technologies ZEBRA Z4M H-974 User Manual

Page 29

Advertising
background image

H-974

PAGE 29 OF 57

0808 IH-974

Leaving the Setup Mode

You can leave the program mode at any time by pressing the SETUP/EXIT key. The
“SAVE CHANGES” display will appear. There are five choices, described below.
Pressing the INCREMENT (+) or DECREMENT (-) key displays other choices and
pressing the SELECT key selects the displayed choice.

PERMANENT -- Permanently saves the changes. Values are stored in the printer
even when power is turned off.

TEMPORARY -- Saves the changes until changed again or until power is turned
off.

CANCEL -- Cancels all changes since pressing the SETUP/EXIT key except the
darkness and tear-off settings (if they were changed).

LOAD DEFAULTS -- Loads factory defaults.

LOAD LAST SAVE -- Loads values from the last permanent save.

Zebra Z4M Printer User’s Guide

39

Configuration and Calibration Sequence

40

Zebra Z4M Printer User’s Guide

Display Shows

Action/Explanation

PRINTER READY

Normal printer operation.

Setting Print Parameters

DARKNESS

Adjusting Print Darkness Press the INCREMENT (+) key to increase darkness.
Press the DECREMENT (-) key to decrease darkness.
Default: +10
Range: 0 to +30
Darkness settings are dependent upon a variety of factors, including ribbon
type, media, and the condition of the printhead. You may adjust the darkness
for consistent high-quality printing.
If printing is too light, or if there are voids in printed areas, you should increase
the darkness. If printing is too dark, or if there is spreading or bleeding of
printed areas, you should decrease the darkness.
The FEED key self test on page 76 can also be used to determine the best
darkness setting. Since the darkness setting takes effect immediately, you can
see the results on labels that are currently printing.
CAUTION: Set the darkness to the lowest setting that provides good print

quality. Darkness set too high may cause ink smearing and/or it
may burn through the ribbon.

Darkness settings also may be changed by the driver or software settings.

TEAR OFF

Adjusting the Tear-Off Position Press the INCREMENT (+) key to increase the
value, press the DECREMENT (-) key to decrease the value. Each press of the
key adjusts the tear-off position by four dot rows.
Default: +0
Range: -120 to +120
This parameter establishes the position of the media over the tear-off/peel-off
bar after printing. The label and backing can be torn off or cut between labels.

Advertising