Zebra Technologies ZEBRA Z4M H-974 User Manual

Page 23

Advertising
background image

H-974

PAGE 23 OF 57

0808 IH-974

Fanfold Media Loading

Fanfold media feeds through either the bottom or rear access slot.

Refer to Figure 19.

1.

Press the printhead open lever. The printhead assembly springs up.

2.

Flip down the media supply guide.

3.

Slide out the media guide as far from the printer frame as possible.

4.

Pass the fanfold media over the media supply hanger.

5.

Flip up the media supply guide. Slide in the media supply guide so that it just
touches, but does not restrict, the edge of the media.

6.

Thread the media under the dancer, through the slot in the transmissive sensor,
under the ribbon sensor, and out the front of the printer.

7.

Ensure that the media is against the back of the transmissive sensor. Then, slide
in the media guide so that it just touches, but does not restrict, the edge of the
media.

8.

Close the printhead assembly.

32

Zebra Z4M Printer User’s Guide

Advertising