Zebra Technologies ZEBRA Z4M H-974 - Manual (Page 6)

H-974
PAGE 6 OF 57 0808 IH-974
Adjusting the Reflective Sensor
Refer to Figure 7.
1. Open the printhead assembly by pressing the printhead open lever.
2. Locate the reflective sensor positioning lever.
3. Move the reflective sensor positioning lever across the width of the media until
the reflective sensor aligns with the start-of-label indicator. The glow of the red
light will assist in the proper placement of the reflective sensor.
4. Close the printhead assembly.
Zebra Z4M Printer User’s Guide 11
Printhead assembly
Reflective
sensor
positioning
lever
Reflective
sensor
Printhead open
lever
Figure 7