Zebra Technologies ZEBRA Z4M H-974 - Manual (Page 44)

H-974
PAGE 44 OF 57 0808 IH-974
Cleaning the Power Peel-Off Module
(Power peel-off option required)
Perform the following procedure if adhesive buildup begins to affect peel
performance.
Refer to Figure 24.
1. Open the printhead assembly.
2. Open the front housing assembly by lifting the two handles; then, pivot down the
front housing assembly.
3. Remove the accumulated adhesive by rolling the sticky side of a blank label
against the peel rollers and lifting it away. (Do this step repeatedly until a
majority of the adhesive is gone.)
4. Use a swab soaked with the Zebra-recommended solvent to remove adhesive
from the tear-off/peel-off bar and reflective surface.
5. Close the front housing assembly.
6. Close the printhead assembly.
58 Zebra Z4M Printer User’s Guide
Printhead
assembly
Front
housing
assembly
Peel
rollers
Tear-off/
peel-off
bar
Handles
Reflective
surface
Figure 24