Zebra Technologies ZEBRA Z4M H-974 - Manual (Page 36)

H-974
PAGE 36 OF 57 0808 IH-974
Zebra Z4M Printer User’s Guide 51
Label Positioning Parameters
Display Shows Action/Explanation
BACKFEED
Backfeed Sequence Press the INCREMENT (+) or DECREMENT (-) key to
display other choices.
Default: Default (90%)
Selections: Default, after, before, 10%, 20%, 30%, 40%, 50%, 60%, 70%,
80%, off
This parameter establishes when and how much label backfeed occurs after a
label is removed or cut in the peel-off or cutter modes. It has no effect in
rewind or tear-off modes. This parameter setting can be superseded by the
~JS instruction when received as part of a label format (refer to the
ZPL II Programming Guide Volume I).
NOTE: The difference between the value entered and 100% establishes how
much backfeed occurs before the next label is printed. For example,
a value of 40 means that 40% of the backfeed takes place after the
label is removed or cut. The remaining 60% takes place before the
next label is printed. A value of “before” means that all backfeed will
take place before the next label is printed.
LABEL TOP
Adjusting Label Top Position Press the INCREMENT (+) key to increase the
value, press the DECREMENT (-) key to decrease the value. The displayed
value represents dots.
Default: +0
Range: -120 to +120 dot rows
The label top position adjusts the print position vertically on the label. Positive
numbers adjust the label top position further down the label (away from the
printhead), negative numbers adjust the position up the label (toward the
printhead).
LEFT POSITION
Adjusting Left Position Press the DECREMENT (-) key to move to the next
position, press the INCREMENT (+) key to change between + and - and to
increase the value of the digit. The displayed value represents dots.
Default: 0000
Range: -9999 to +9999
NOTE: For a negative value, enter the value before changing to the minus
sign.
This parameter establishes how far from the left edge of a label the format will
begin to print by adjusting horizontal positioning on the label. Positive
numbers adjust the printing to the left by the number of dots selected,
negative numbers shift printing to the right.