Petzl EXO EASHOOK - Manual (Page 6)

6 EXO CE SACOCHE D305100A (040808)
9
Installation on the harness
The EXO must always be connected to the harness attachment
point.
An extended attachment point allows the OK TRIACT BAR to be
permanently connected to the harness with the bag attached at the
side.
Pay attention to the orientation of the OK TRIACT BAR in the
attachment point because this determines the correct position of the
descender during evacuation (see drawing). Make sure the gate is
correctly closed and locked.
Good
position
Defining and making an anchor
is a topic that is too complex to
be fully described in this notice.
Only a few examples are shown.
You must learn how to make an
anchor during your training.
Anchor the rope to a solid fixed
anchor using the rope end
connector (10 kN).
WARNING DANGER OF
DEATH: your rope must not be
in contact with an edge that is
sharp or abrasive or having a
high temperature.
WARNING, the rope end
connector must not be loaded
over an edge (for example on a
beam), because its strength will
be reduced.
10
Installation on the anchor