Philips HR1870 - Manual (Page 8)

Note: The integrated foam separator ensures clear juice as an end result.
9 Place the juice jug under the spout (Fig. 10).
Note: If you want to extract juice straight into a glass, use the spout accessory (Fig. 11).
using the juicer
The appliance only functions if all parts are assembled correctly and the locking arm is in locked
position.
1 Wash the fruit and/or vegetables and, if necessary, cut them into pieces that fit into the
feeding tube.
2 Make sure the juice jug is placed directly under the spout (Fig. 10).
Note: If you want to extract juice straight into a glass, use the spout accessory.
3 Turn the control knob to setting 1 (low speed) or 2 (normal speed) to switch on the
appliance (Fig. 12).
Note: For hard fruits or vegetables (e.g. apples, beetroots and carrots) we advise you to use speed 2
(normal speed). For soft fruits or vegetables (e.g. berries, kiwi, grapes, tomatoes, cucumber and melon) we
advise you to use speed 1 (low speed).
4 Put the pieces in the feeding tube and gently press them down towards the rotating filter
with the pusher (Fig. 13).
Do not exert too much pressure on the pusher, as this could affect the quality of the end result. It
could even cause the filter to come to a halt.
Never insert your fingers or an object into the feeding tube.
5 Align the groove of the pusher with the small protrusion on the inside of the feeding tube
and slide the pusher into the feeding tube (Fig. 13).
6 When you have processed all ingredients or when the integrated pulp container is full, switch
off the appliance and unplug it. Wait until the filter stops rotating.
7 To empty the integrated pulp container, remove the lid, the filter and the juice collector.
8 For maximum flavour and freshness, serve the juice immediately after preparation.
Note: If you want to store the juice in the refrigerator, make sure the lid is on the juice jug.
Citrus press
Preparing the citrus press for use
1 Assemble the gear box onto the motor unit (Fig. 14).
2 Assemble the sieve holder onto the motor unit (Fig. 15).
3 Assemble the sieve onto the sieve holder (Fig. 16).
4 Assemble the cone onto the gear box (Fig. 17).
5 Lift the locking arm to locked position (‘click’). (Fig. 18)
6 Place the juice jug under the spout (Fig. 19).
Note: If you want to extract juice straight into a glass, use the spout accessory.
EnglisH 8