Yukon NVMT Spartan 5 - Manual (Page 6)

CR123A
При необходимости нажмите кнопку действия инфракрасного излучения (3),
которая расположена рядом с кнопкой включения прибора, для усиления видимости в темных условиях.
Наведите Ваш прибор на объект, удаленный на расстоянии около 100 м и вращением окуляра (4)
и объектива (5) добейтесь максимального качества изображения.
После данной настройки в независимости от расстояния и других условий не вращайте окуляр.
44
Your NVMT Spartan 5 runs on one battery - 3V Lithium CR123A. To install, unscrew the battery compartment cover,
insert the battery into the battery compartment so that the positive (+) and negative (-) terminals of the battery
match the markings inside the compartment. Replace the battery cover carefully. Do not over tighten.
Unscrew the Laser Pointer battery compartment cover (6), insert the LR44 battery into the battery compartment
so that the positive (+) and negative (-) terminals of the battery match the markings inside the compartment.
Replace the battery cover carefully. Do not over tighten.
Always store the NVMT Spartan 5 in a dry, well-ventilated room.
Keep the NVMT Spartan 5 away from any heating and air conditioning vents or other heating devices.
Keep the NVMT Spartan 5 out of direct sunlight, dust and moisture. Additional precautions include avoiding any sudden
or extreme temperature changes.
Avoid dropping or otherwise shocking the unit. Although designed for rugged outdoor use, the NVMT Spartan 5
incorporates a sophisticated optical system, which can be damaged if misused.
BATTERY INSTALLATION
USE AND TESTING
Your NVMT Spartan 5 operates using one CR123A battery. Make sure it has been installed according to instructions found
in the Battery Installation section of this manual.
If you wish to test your night vision device in a lighted area, be sure the lens cap is in place prior to pressing
the “ON” button. The lens cap has a pinhole opening to admit a small amount of light for testing purposes.
Move into a dark area before activating the NVMT Spartan amplifier.
Remove the lens cap (1) and store in pocket provided.
Activate the device by pushing the “ON” button (2).
If the subject to be viewed is in a completely dark area, including low light shadow areas, activate the infrared
illuminator by pressing the “IR” Button (3) located next to the “ON” button.
Damage to this device from failure to observe these warnings may void the warranty!
A. Monocular (See Figure 1)
3
Рисунок 1
LR44