Activeforever Invacare Bariatric Electric Hospital Bed (Bariatric Home Care Hospital Bed) - Manual (Page 25)

SECTION 5—PACKAGING, HANDLING AND SET-UP
Part No 1123842 25 IVC™ Bariatric Bed
9. Assemble and install the drive shaft. Refer to Assembling/Installing/Removing Drive
Shaft on page 30.
10. Activate the bed functions. Refer to Inspecting the Bed on page 32.
Disassembling
1. Lower the head and foot sections completely. Refer to Raising and Lowering Head and
Foot Sections on page 16.
2. Lower the bed to the lowest height. Refer to Raising and Lowering Entire Bed on
page 16.
3. Remove the drive shaft. Refer to Assembling/Installing/Removing Drive Shaft on
page 30.
4. Disconnect the head actuator jumper cable.
5. Remove both universal bed ends. Refer to Installing/Removing Universal Bed Ends on
page 26.
NOTE: Place the bed on a flat surface so that the motor guards on the bottom of the frame are
supporting the bed.
6. Starting with one side of bed, pull the release pin and pull the head section so that it
starts to separate slightly from the foot section.
7. On the opposite side of bed, pull the release pin.
8. Separate the head section from the foot section.
FIGURE 5.3 Assembling/Disassembling Head and Foot Sections
NOTE: Motor guards located
on underside of frame
sections.
Locking Pin
Head Section
(Inside)
Foot Section
(Inside)
Foot Section
Head Section