Activeforever Invacare Bariatric Electric Hospital Bed (Bariatric Home Care Hospital Bed) - Manual (Page 26)

SECTION 5—PACKAGING, HANDLING AND SET-UP
IVC™ Bariatric Bed 26 Part No 1123842
Installing/Removing Universal Bed Ends
ƽ WARNING
DO NOT place your hand between the head section and the universal bed end while
assembling. Otherwise, injury may occur.
NOTE: For this procedure, refer to FIGURE 5.4.
NOTE: Reverse this procedure to remove the universal bed ends.
1. Stand one bed end as close to the head section as possible.
2. With one hand, grasp the head section and raise it until the corner plate head rivets of
the section are high enough to place into the corner locks on the bed end.
3. Tilt the bed end toward the head section and place the corner plate head rivets into the
corner locks.
4. Return the universal bed end to its full upright position. The corner plate head rivets
will lock into place.
5. Repeat STEPS 1-4 to install the remaining bed end to the foot spring section.
6. If necessary, install the casters. Refer to Installing Casters on page 26.
FIGURE 5.4 Installing/Removing Universal Bed Ends
Installing Casters
ƽ WARNING
Ensure that the locking casters are installed diagonally from each other and are
locked. Otherwise, damage or personal injury could occur.
The proper casters are provided with the Bariatric Bed. DO NOT use any other
casters with the Bariatric Bed. Otherwise, damage or personal injury could occur.
Ensure that casters are locked and that the bed does not move before transferring.
DO NOT transfer occupant if bed is not stable.
NOTE: For this procedure, refer to FIGURE 5.5 on page 27.
Bed End
Bed End
Corner Plate
Head Rivets
Corner Plate
Head Rivets
Rivets Rivets
Corner Locks
Corner Locks
Foot Section
Head Section