VEGA VEGAFLEX 81 HART - integrated accumulator - Manual (Page 14)

14
3 Product description
VEGAFLEX 81 • HART - integrated accumulator
44640-EN-130430
•
Avoiding mechanical shock and vibration
•
Storage and transport temperature see chapter "Supplement -
Technical data - Ambient conditions"
•
Relative humidity 20 … 85 %
3.4 Accessories and replacement parts
The display and adjustment module PLICSCOM is used for measured
value indication, adjustment and diagnosis. It can be inserted into the
sensor or the external display and adjustment unit and removed at
any time.
You can find further information in the operating instructions "Display
and adjustment module PLICSCOM" (Document-ID 27835).
The interface adapter VEGACONNECT enables the connection of
communication-capable instruments to the USB interface of a PC. For
parameter adjustment of these instruments, an adjustment software
such as PACTware with VEGA-DTM is required.
You can find further information in the operating instructions "Interface
adapter VEGACONNECT" (Document-ID 32628).
The protective cover protects the sensor housing against soiling and
intense heat from solar radiation.
You will find additional information in the supplementary instructions
manual "Protective cover" (Document-ID 34296).
The electronics module VEGAFLEX series 80 is a replacement part
for TDR sensors of VEGAFLEX series 80. There is a different version
available for each type of signal output.
You can find further information in the operating instructions manual
"Electronics module VEGAFLEX series 80".
The supplementary electronics is a replacement part with integrated
accumulator for the following sensors:
•
VEGAPULS series 60
•
VEGAFLEX series 80
•
VEGABAR series 80
You can find further information in the operating instructions "Sup-
plementary electronics for 4 … 20 mA/HART and power pack"
(Document-ID 41033).
Storage and transport
temperature
PLICSCOM
VEGACONNECT
Protective cap
Electronics module
Supplementary electron-
ics power pack